Manual

Page 11
SnowBlind™ Manual - Rev. A Copyright (c) 2012 Blizzard Lighting, LLC
DMX Values In-Depth (3 Channel Mode)
Ch. Value What It Does
1 000 <--> 255 Dimmer (Low <--> High)
2 000 <--> 255 Flash Speed (Slow <--> Fast)
3
000 <--> 009
010 <--> 255
No Function
Microphone Sensitivity (Low <--> High)
Troubleshooting
Symptom Solution
Fixture Auto-
Shut Off
Checkthefaninthexture.Ifitisstoppedormov-
ing slower than normal, the unit may have shut itself
offduetohighheat.Thisistoprotectthexturefrom
overheating. Clear the fan of obstructions, or return the
unit for service.
Beam is Dim Check optical system and clean excess dust/grime. Also
ensure that the 220V/110V switch is in the correct posi-
tion, if applicable.
No Light Out-
put
Checktoensurextureisoperatingundercorrect
mode,IEsoundactive/auto/DMX/Etc.,ifapplicable.
Chase Speed
Too Fast/Slow
Check to ensure proper setup of speed adjustment.
No Power Check fuse, AC cord and circuit for malfunction.
Blown Fuse Check AC cord and circuit for damage, verify that mov-
ing parts are not restricted and that unit’s ventilation is
not obstructed
Slow Move-
ment
Verify that 220V/110V switch is in the correct position,
if applicable. Also check that speed channels are set
appropriately.
No Response
to Audio
Verifythatthextureisin“SoundActive”mode.
Adjust Audio Sensitivity, If Applicable.
Fixture Not
Responding /
Responding
Erraticly
Make sure all connectors are seated properly and se-
curely.
Use Only DMX Cables and/or check cables for defects
Install a Terminator.
Resetxture(s).
Intermittant
Lamp
Check lamp for properly installation.
Relamp, lamp may have reached end of life.