Manual

SNOKONTROL Manual Rev B.
Page 11
3.3 Programming
A program (bank) is a sequence of different scenes or steps which are called one after another.
SNOKONTROL can store up to 30 programs of 8 scenes each.
3.3.1 Entering Program Mode
1. Make sure that MANUAL mode is selected.
2. Press and hold the <PROGRAM> button until the Program LED blinks rapidly.
3.3.2 Create A Scene
A scene is a static lighting look. Scenes are stored in banks. SNOKONTROL features 30 bank
memories, and each bank holds up to 8 scenes. In total, SNOKONTROL is capable of storing up
to 240 scenes.
1. Ensure that the BLACKOUT LED is not lit. If it is, press the <BLACKOUT> button
to deselect.
2. Press and hold the <PROGRAM> button until the Program LED blinks rapidly.
3. Set the SPEED and FADE TIME sliders at their lowest level.
4. Selectthexture(s)youwishtoincludeinthescenebypressingtheappropriate
<SCANNER> buttons.
5. Create your look by using the sliders.
6. Tap the <MIDI/ADD> button.
7. Using the <BANK UP> and <BANK DOWN> buttons, select a bank from
01-30.
8. Using the <SCENES> button, select the scene (1-8) that you wish to program. All
LEDswillashtoconrm.TheLEDdisplaywillindicatethescenenumber
(1-8)
which was programmed.
9. Repeat steps 5-7 as necessary. Up to 8 scenes may be recorded to each program
bank.
10. To exit program mode, press and hold the <PROGRAM> button.
3.3.2.1 Review A Scene Or Chase
This section assumes that you have already recorded scenes and chases in the controller.
To Review a Scene:
1. Select any one of the 30 banks by pressing the <BANK UP>/<BANK DOWN>
buttons.
2. Select a <SCENE> button (1-8) to review.
3. Movethefaderstochangextureattributes.
To Review a Chase:
1. Press any one of the 6 <CHASE> buttons.
2. Press the <TAPSYNC DISPLAY> button to view the step number on the display.
3. Press the <BANK UP>/<BANK DOWN> buttons to review all scenes in the chase.
3.3.3 Running A Program
1. Use the <BANK UP>/<BANK DOWN> buttons to change program banks as
needed.