Manual

SNOKONTROL Manual Rev B.

Page 10

3.1.4 Resetting The System

WARNING: This will reset the controller to its factory defaults. ALL PROGRAMS AND SETTINGS

WILL BE ERASED!

1. Turn the unit off.

2. Press and hold <BANK UP> & <AUTO/DEL>

3. Turn the unit on while you continue to hold <BANK UP> & <AUTO/DEL>

4. The settings will be reset to factory defaults.

3.1.5 Fixture Copy

This allows the user to copy the attributes of one xture to another (IE Scanner 1 to Scanner 2)

1. Press and hold the <SCANNER> button to be copied.

2. Whileholdingtherstbutton,pressandholdthe<SCANNER> button to receive

the copied data.

3. Releasetherst<SCANNER> button, then the second.

4. TheScannerLEDindicatorswillashtoconrmasuccessfulcopy.

3.1.6 Fade Time Assign

This allows the user to assign fade times either globally or to PAN/TILT channels only. This is

useful because typically the user will not want to fade gobos/colors/etc.

1. Turn the controller off.

2. Hold the <BLACKOUT> and <TAPSYNC DISPLAY> buttons simultaneously.

3. Turn the controller on.

4. Press the <TAPSYNC DISPLAY> button to toggle between the two modes. Either

all channels (

A) or PAN/TILT channels only (P).

5. Press <BLACKOUT> and <TAPSYNC DISPLAY> to save the setting. All LEDs

willblinktoconrmtheselection.

3.2 Manual Mode

Manual mode allows direct control of all scanners. You are able to move them and change attri-

butes by using the channel faders.

Note: All changes made while in Manual Mode are temporary and will not be recorded.

1. Press the <AUTO DEL> button until the Auto Trigger LED is unlit.

2. Select a <SCANNER> button.

3. Movethefaderstochangextureattributescorrespondingwitheachfaderchannel.

4. Pressing the <TAPSYNC DISPLAY> button toggles between displaying the DMX

value (

0-255) and percentage (0-100)