Manual

Page 9

Fixture Linking (Master/Slave Mode)

1. Connect the (male) 3 pin connector side of the

DMX cable to the output (female) 3 pin connector of



2. Connect the end of the cable coming from





consisting of a (male) 3 pin connector. Then,

proceed to connect from the output as stated above



A quick note: Often,

the setup for Master-

Slave and Standalone





chain be initialized for

this purpose via either

settings in the control

panel or DIP-switches.



that follow may also



Check the “Operating Adjustments” section in this manual for



Mounting & Rigging



enough room for ventilation.

It is important never to obstruct the fan or vents pathway. Mount the





stability. Do not mount to surfaces with unknown strength, and ensure









replacement access (if applicable) and routine maintenance.





high humidity, extreme temperature changes or restricted ventilation.