Owner's manual

Page 12

DMX Mode

Allows the unit to be controlled by any universal DMX controller.

1.) The default mode for the xture is DMX, which appears as ADDR

on the LED Readout. To select a different DMX address, hit the

<ENTER> button and use the <UP/DOWN> buttons to select the

correct address, then hit <ENTER> to conrm.

Auto, Master/Slave, Sound Active Modes:

Allows a single or Master/Slaved units to run factory installed programs at user

selectable speeds.

1.) To use the xture in 3 channel or 6 channel mode, use the

<MENU> and <UP/DOWN> buttons to select CHND and hit the

<ENTER> button. Then use the <UP/DOWN> buttons to select

either3CH or 6CH. Press the <ENTER> button to conrm.

2.) To set the xture in automatic mode, use the <MENU> and <UP/

DOWN> buttons to select SHND, hit <ENTER>. Then use the <UP/

DOWN> buttons to select COLO and hit <ENTER>. Then use the

<UP/DOWN> buttons to select AUTO , and press <ENTER>.

3.) To use the xture as either a master or slave unit, use the

<MENU> and <UP/DOWN> buttons to select SLND and then hit the

<ENTER> button. Then select either NAST for master or SLAU for

slave. Press the <ENTER> button to conrm.

4.) To adjust the speed of the chase navigate to FADE, hit <ENTER>,

and select SP 1 (slowest) to SP 8 (fastest). Press the <ENTER>

button to conrm.

Sound Acitve Mode:

1.) To use this xture in sound active mode, select SHND, then press

the <ENTER> button. Then select SOUN and hit enter.

Manual Color Adjustment:

Allows the user to adjust the color balance of the xture. These settings are

global, they will effect all modes.

1.) use the <MENU> and <UP/DOWN> buttons to select NANU and

hit the <ENTER> button.

2.) Then use the <UP/DOWN> buttons to scroll to either RED

(red), GREE (green), or BLUE (blue), and press <ENTER>. Select

the maximum level for each color between 0-255 (0=off), then hit

<ENTER> to conrm.