Manual

Page 12

DMX Mode

Allows the unit to be controlled by any universal DMX controller in one of 2 channel modes.

1.) The default mode for the ﬁ xture is DMX, which appears as

A001 on the LED

Readout.

2.) To select the DMX personality (channel mode), select either

3 Ch (3-Chan-

nel Mode), or

5 Ch (5-Channel Mode), then hit <ENTER> to conﬁ rm.

3.) Then, use the <UP/DOWN> buttons to select the correct address between

A001-A512, then hit <ENTER> to conﬁ rm.

Stand-Alone, Master/Slave, Sound Active Modes:

Allows a single or Master/Slaved units to run factory installed programs at user selectable

speeds.

1.) To set the ﬁ xture in one of 3 standalone automatic operating modes, select

RuN 0 - RuN 2

To conﬁ rm, press the <ENTER> button.

2.) To set the ﬁ xture to a speciﬁ c color (or color scroll), use the <MENU> button

to reach

P000-P255. This value corresponds to the DMX value for the color

channel you wish to display. For instance, to display Yellow, you would select

a value between

P080-P111. To select a medium-speed clockwise color

scroll, you would select a value around

P160, then press the <ENTER> button

to conﬁ rm. (See DMX Values on P. 13)

3.) Next, use the <MENU> button to reach

L000-L255. This value cor-

responds to the DMX value for the dimmer channel. For instance, to cause the

ﬁ xture to output at approximately 25%, you would select a value of

L064. To

cause the ﬁ xture to output at 100%, you would select

L255, then press the

<ENTER> button to conﬁ rm.

4.) To set the ﬁ xture as a slave unit, select

A001, and hit <ENTER>.

Sound Active Mode:

1.) To use sound active mode, select

Soud, then press the <ENTER> button

to conﬁ rm.

To Turn the LED Display On/Off:

Allows the user to enable/display the LED display while the ﬁ xture is in operation.

1.) Use the <MENU> button to reach LEoN / LoFF

2.) Now, select the status by using the <UP> and <DOWN> buttons to select

LEoN (LED Display On), or LoFF (LED Display Off). To conﬁ rm, press the

<ENTER> button.