User Manual

Page 12
Q-Stick™ RGBW Manual Rev. B Copyright (c) 2012 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the xture is DMX, which appears as either
F/P/A/.001 on the LED Readout, depending on the channel mode. To se-
lect a different DMX address, using the <MENU> button, select
Addr, then hit
<ENTER>. Use the <UP/DOWN> buttons to select the correct address, then
hit <ENTER> to conrm.
2.) To set the xture to 4 (“A”), 5 (“P”), or 7 (“F”) channel mode, use the
<MENU> button to select
cH--, then hit <ENTER>. Use the <UP/DOWN>
buttons to select the desired channel mode between
F.001 , (7-Channel
Mode),
P.001 , (5-Channel Mode), or A.001 , (4-Channel Mode), then hit
<ENTER> to conrm.
Stand-Alone, Master/Slave, Sound Active Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable
speeds.
1.) To set the xture in Flash/Fade mode, select FLAS or FAdE
To conrm, press the <ENTER> button.
2.) Now, use the <UP/DOWN> buttons to select the desired speed from
000
(slowest), to
100 , (fastest), then hit <ENTER> to conrm.
3.) To use the xture in automatic mode, select
ASC-, then press the <EN-
TER> button to conrm.
4.) Again, use the <UP/DOWN> buttons to select the desired speed from
000
(slowest/off), to
100 , (fastest), then hit <ENTER> to conrm.
5.) To set the xture as a slave unit, select dmx mode, channel
F.001, and hit
<ENTER>.
Auto Mode:
Allows a single unit to display a variety of colors and programs without a DMX controller.
1.) To set the xture in auto mode, select AuTo.
To conrm, press the <ENTER> button.
2.) Now, select the program speed by using the <UP> and <DOWN> buttons to
select
000 (slowest), to 049 , (fastest), then hit <ENTER> to conrm.
Sound Active Mode:
Allows the xture to respond to sound input without a DMX controller.
1.) To set the xture in sound active mode, rst select AuTo.
To conrm, press the <ENTER> button.
2.) Now, select the sound sensitivity by using the <UP> and <DOWN> buttons
to select
050 (least sensitive), to 100 , (most sensitive), then hit <ENTER>
to conrm.