User guide

Page 13

Color Calibration Settings:

1.) Press the <MENU> button, then use the <UP/DOWN> buttons until the display reads CAL and press

the <ENTER> button

2.) Press the <UP/DOWN> buttons until the display reads RED (Red intensity, 0-255), GREN (Green inten-

sity, 0-255), BLUE (Blue intensity, 0-255), WHIT (White intensity, 0-255), or AMB (Amber intensity, 0-255)

and adjust to your desired values.

4.) Push the <ENTER>buttontoconrmandsave.

5.) Press the <UP/DOWN> buttons until the display reads

USE and push the <ENTER> button. Then to

activate/deactivate these settings, select either

On or OFF.

6.) Push the <ENTER>buttontoconrmyourchoice.

Slave Mode:

1.)Thereisnoneedtomanuallysetadditionalxturestoslavemode.FixturesthatarelinkedintheDMX

chainaftertherstunit(master)willreceivedataautomaticallyandfunctionasthemasterxturedoes.

LED Display On/Off:

1.) Press the <MENU> button until the display reads DISY and press the <ENTER> button.

2.) Press the <UP/DOWN> buttons until the display reads either

On or IM. When On is active, the LED dis-

play will be turned on continually. When IM is active, the LED display will shut off after 1 minute of inactivity.

3.) Push the <ENTER>buttontoconrmyourchoice.

Fixture Reset (Last saved values):

1.) Press the <MENU> button until the display reads REST and press the <ENTER> button.

2.) Press the <UP/DOWN> buttons until the display reads

YES .

3.) Push the <ENTER>buttontoconrmyourchoice.

Restore Factory Settings:

1.) Press the <MENU> button until the display reads LOAD and press the <ENTER> button.

2.) Press the <UP/DOWN> buttons until the display reads

YES .

3.) Push the <ENTER>buttontoconrmyourchoice.

Send Data to Other Fixtures:

1.)Linkyourmaster/slavedxturesDMXin/out.

1.) Disconnect the DMX cable from your controller (if applicable).

1.) Press the <MENU> button until the display reads

SEND and press the <ENTER> button.

2.) Press the <UP/DOWN> buttons until the display reads

YES .

3.) Push the <ENTER>buttontoconrmyourchoice.

Note: The settings of <ADDR> and <CAL>willnotbesent.Theslaved/receivingxture(s)willresetauto

matically after receiving the data correctly.