User Manual

Page 12
ROCKLITE RGBAW Manual Rev. B Copyright (c) 2010 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the xture is DMX, which appears as d001 on the LED
Readout. To select a different DMX address, using the <MENU> button, select
Addr,then hit <ENTER>. Use the <UP/DOWN> buttons to select the correct
address, then hit <ENTER> to conrm.
Stand-Alone, Master/Slave, Sound Active Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable
speeds.
1.) To set the xture in Flash/Fade mode, select FLASorFAdE
To conrm, press the <ENTER> button.
2.) Now, select the ash or fade speed using <MENU> button to reach SP--,
then hit <ENTER>.
The display reads SP15(slowest) toSP00(fastest), then press the <EN-
TER> button to conrm.
3.) To use the xture in automatic mode, select ASC-, then press the <EN-
TER> button to conrm.
4.) Adjust the speed of the chase as above using SP15 (slowest) to SP00
(fastest) then press the <ENTER> button to conrm.
5.) To set the xture as a slave unit, select SLAV, and hit <ENTER>. The unit
will display a ashing SL-U to indicate it is in slave mode.
Sound Acitve Mode:
1.) To use sound active mode, select SouA, then press the <ENTER> button
to conrm.
Standalone (Program) Mode:
Allows a single unit to display a variety of colors and programs without a DMX controller.
1.) To set the xture in manual mode, select Pr--.
To conrm, press the <ENTER> button.
2.) Now, select the program by using the <UP> and <DOWN> buttons to select
Pr00-Pr15. To conrm, press the <ENTER> button.
Manual Color Adjustment:
Allows the user to adjust the color balance of the xture. These settings are global, they
will effect all modes.
1.) Use the <MENU> and <UP/DOWN> button to select rL--(Red Level),
GL--(Green Level), bL--(Blue Level), AL--(Amber Level), or UL--
(White Level), then hit <ENTER>.
2.) Using the <UP/DOWN> buttons, select the maximum level for each color
between x000-x255 (000=off), then hit <ENTER> to conrm.