User Manual

Page 14
The Puck: Unplugged RGB Manual Rev. B Copyright (c) 2011-2012 Blizzard Lighting, LLC
4. OPERATING ADJUSTMENTS
NOTE: After making any adjustment, hold the <MENU> button for approximately
3 seconds, otherwise the xture will return to the correct mode after approxi-
mately 10 seconds.
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the xture is DMX, which appears as
Addr on the LED
Readout. Use the <ENTER> button then the <UP> and <DOWN> buttons to
choose a channel between
1 and 512. Press <ENTER> again to conrm.
2.) To change between 3 and 6 channel DMX mode, select
ChNd, then press
<ENTER>. Select either
6Ch or 3Ch, then press <ENTER> again to con-
rm.
Master/Slave Mode (Auto/Sound Active/Color Preset/Custom):
Allows you to link up to 32 units together without a controller.
1.) Use standard DMX cables to daisy chain your units together via the DMX con-
nector on the rear of the units.
2.) Choose a unit to function as the Master. Select MAST. The master unit must
be the rst unit. Finally, chain the units together using DMX cable.
Master
SLNd then NASt to conrm.
3.) Select slave function by using the <UP>/<DOWN> keys to reach SLAV in
the Master/Auto menu on the slave units, and they will react in the same as the
Master.
Slave
SLNd then SLAu to conrm.
NOTE: Fixtures in slave mode will display “
STBY“ (Standby). This is NORMAL.
Return the xture to master mode to use it as a standalone xture.
4.) On the master xture, use the <UP>/<DOWN> keys to reach SHND, which
allows you to select the Master/Slave mode.
Sound active
SoUn then <ENTER> to conrm.
Auto mode
CoLo then Auto, then <ENTER> to conrm.
Color preset
CoLo then CoL 1 - CoL 7, <ENTER>.
Fade Mode
FAdE then SP 1 - SP 8, <ENTER>.
NOTE: Speed 1 = Fastest (Approx. 1.5 sec. per color), Speed 8 = Slowest (Approx.
2 min. per color).