User guide

Page 13

TO DISPLAY FIXTURE RUNNING HOURS:

1.) Press the <MENU> button until the display shows hour

2.) Press <ENTER> to conrm your selection.

TO SET THE FIXTURE IN TEST MODE:

1.) Press the <MENU> button until the display shows TEST

2.) Press <ENTER> to conrm your selection.

TO SET THE LED DISPLAY MENU ON/OFF AFTER 5 SECONDS:

1.) Press the <MENU> button until the display shows LED

2.) Use the <+/-> buttons to set to the desired position,

press <ENTER> to conrm.

TO SET THE STANDBY MODE OF THE FIXTURE (when not receiving DMX

signal):

1.) Press the <MENU> button until the display shows STbY

2.) Use the <+/-> buttons to set to the desired position,

press <ENTER> to conrm.

Stand-Alone Mode (Auto or Sound Active Mode):

Allows a single unit to run to a factory installed program.

1.) Press the <MENU> button until it shows AuTo orSouN and

press <ENTER> to conrm.

2.) Use the <+/-> buttons to set to the desired position,

press <ENTER> to conrm.

Master/Slave Mode (Auto or Sound Active):

Allows you to link up to 32 units together without a controller.

1.) Use standard DMX cables to daisy chain your units together via the DMX con-

nector on the rear of the units. It may be necessary to use a terminator at the

last xture. For more information about terminators, see page 8.

2.) Choose a unit to function as the Master. Select NAST/SL 1 or SL 2 depending

upon which master / Slave mode you want. Slave 1 mode causes all xtures to

react the same. Slave 2 mode causes those xtures to react in a complimentary

way to those set as master / Slave 1. The master unit must be the rst unit.

Finally, chain the units together using DMX cable.

DMX Mode

Allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with

DMX, please read the DMX Primer on page #17.

1.) The default mode for the xture is DMX, which appears as

A001 on the LED

Readout.