User guide

Page 12

DMX Mode

Allows the unit to be controlled by any universal DMX controller.

1.)Dependingonwhatchannelmodeyouwouldliketouse,yourstneedto

chooseoneofthefourDMXchannelmodecongurations:

Nod1

- To choose 4 channel DMX mode

Nod2 - To choose 7 channel DMX mode

Nod3 - To choose 16 channel DMX mode

Nod4 - To choose 34 channel DMX mode

Use the <UP/DOWN> buttons to scroll to Nod - and push the <ENTER>

button. Then use the <UP/DOWN> buttons to scroll to your choice of 4/7/16

or 31 channel mode, then hit the <ENTER> button.

2.) Then depending on which DMX channel mode you entered, you can set the

DMXstartingaddress.You’llnoticethattherstletterinthissettingchanges

per mode:

C001 - C512 - To set the starting address of Mode 1 (4ch)

d001 - d512 - To set the starting address of Mode 2 (7ch)

E001 - E512 - To set the starting address of Mode 3 (16ch)

F001 - F512 - To set the starting address of Mode 4 (34ch)

Use the <UP/DOWN> buttons to scroll to C ---, d ---, E ---, or F --- and push

the <ENTER> button. Then use the <UP/DOWN> buttons to scroll to your

choice (1-512), then hit the <ENTER> button.

Master/Slave Modes:

Allows a single or Master/Slaved units to run factory installed programs at user

selectable speeds.

1.TherstxtureintheDMXchainwillserveasthemasterunit.Tosetother

xturesinlinetoslavemode,makesurethesextureshaveastartingDMX

address that is set to match that of the master unit.

Forexample,ifyourmasterxturehastheDMXstartingaddressofC001, all

otherxtureslinkedintheDMXchainmustmatchthatDMXstartingaddressof

C001.Thesextureswillnowfunctionexactlyasthemasterdoes.