Owner's manual
Page 12
The PinUp™ RGBW Pinspot Rev. A Copyright (c) 2012 Blizzard Lighting, LLC
DMX Mode:
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the xture is DMX, which appears as A001 on the LED
Readout. Use the <ENTER> button then the Up/Down buttons to choose a
channel between 001 and 512. Press <ENTER> again to conrm.
Setting up for Master/Slave:
1.) Use standard DMX cables to daisy chain your units together via the DMX
connectors on the rear of the units. The rst xture in line from the DMX controller
will serve as the Master.
2.) Then, to set your other xtures to run in Slave Mode, you will need use the
Up/Down buttons to select Run0, and press the <ENTER> button on the control
panel menu to conrm your choice. These xtures will now be set to slave mode and
controlled by the master unit.
Auto Mode:
1.) Use the Up/Down buttons to navigate to starting main menu setting Run0
(or
last saved menu option).
2.) Then, use the Up/Down buttons to navigate to Run1 - RunC, press the
<ENTER> button on the control panel menu to conrm your choice
(see page 11 for
descriptions).
Sound Active Mode:
1.) Use the Up/Down buttons to navigate to starting main menu setting Run0
(or
last saved menu option).
2.) Then, use the Up/Down buttons to navigate to Sou1 - Sou3, press the
<ENTER> button on the control panel menu to conrm your choice
(see page 11 for
descriptions).
LED Display (On/Off):
1.) Use the Up/Down buttons to navigate to the starting main menu setting LEon
(default).
2.) Then, use the Up/Down buttons to navigate to settings LEon (ON) or LoFF
(OFF), and press the <ENTER> button on the control panel menu to conrm your
choice.