User Manual

PRETTY PICTURES FOR YOU TO LOOK AT... OPERATION

Antenna

Transmission Power

Level Button

Frequency Group

Button

Transmit LED Receive LED

Power Switch

Mounting Tabs

LCD Display

DMX In DMX Out

DC Power In

Antenna

Terminal

BACK

FRONT

Operation Mode (1)

Operating Frequency (2)

Power Level (3)

Channel Group ID (4)

The LCD display onboard the LightCaster Wireless DMX transceiver gives

you all pertinent information about the unit’s operating mode. Below, each

symbol is described:

1.) Operation Mode: Gives the mode of the unit, either Transmitter (“T”),

Receiver (“R”), or Searching (“-”).

2.) Operating Frequency: Displays the current operating frequency while

the unit is in Transmitter or Receiver Mode. While in Searching mode, the

unit will display the current frequency being scanned.

3.) Transmission Power Level: Displays the current transmission power

(applicable for Transmitter Mode Only):

• “0” = 2dBm (Lowest)

• “1” = 8dBm

• “2” = 14 dBm

• “3” = 20 dBm (Highest)

To change the transmission power level, use the “PA” button located on the

front panel.

4.) Channel Group ID: Displays the current channel group (0-9, A-F). In

auto mode, the transmitting unit will autoselect the clearest channel group.

When a receiving unit in a single-group setup is powered on, it will auto-

matically sync to the transmitter. In multiple transmitter/receiver setups,

manual conﬁ guration may be required.

To manually conﬁ gure the channel group ID, use the “ID” button on the front

panel. Set each transmitter/receiver group to the same group ID to ensure

correct operation.