User guide

Page 13

2. Press the <RUN MODE> button until the LED indicator for MANUAL

mode is illuminated.

3. Using the <LEFT/RIGHT> buttons, move through the steps in the se

lected chase.

3.5.4 Playback Override

Allows the user to manually override the current output while in Color/Scene

Preset or Chase Playback Mode.

1. Ensure that BLACKOUT mode is not selected, IE that the LED indicator

above the <BLACKOUT> button is not lit.

2. Using the <FIXTURE SELECTOR> button(s),selectthexturestobe

controlled.

3. Adjust the color output using <FADER 1-5> as desired.

4. To return to Color/Scene Preset or Chase Playback Mode, press <DEL/

CLEAR>.

3.5.5.1 Strobe Setup

Allows the user to set the channel/channels which will be controlled by the

strobe function, for each xture.

1. Enter programming mode as described in Section 3.2.1.

2. Press the <STROBE> button.

3. Using the <FIXTURE SELECTOR> button(s),selectthexturesto

setup.

4. Using the <LEFT/RIGHT> buttons, select the channel to adjust.

5. To enable the strobe function on the channel selected, press the

<EDIT/REC> button.

6. To disable the strobe function on the channel selected, press <DEL/

CLEAR>.

7. Repeatsteps2-7toadjustadditionalchannels/xturesasdesired.

8. Hold <EDIT/REC> for 3 seconds to exit programming mode. The LED

indicator above the <EDIT/REC> button will extinguish.

3.5.5.2 Strobe Playback

Allows the user to strobe the current playback. Note: Strobe operates even

when the <BLACKOUT> button is active.

1. Press and hold the <STROBE> button. All currently selected/operating

xtureswillstrobe.

2. Using the <STROBE SPEED> fader, adjust the strobe speed, from 1 to

20ashespersecond.

3. Release the <STROBE> button, and strobing will stop.

3.5.6 Blackout

Allows the user to stop all xture output immediately (except while strobing is

active).

1. Press the <BLACKOUT> button. All output will cease. The LED indica-

tor will illuminate.

2. Press the <BLACKOUT> button again, and playback will resume