Owner's manual

Page 10

Dipswitch #1 #2 #3 #4 #5 #6 #7 #8 #9 #10

Value 1 2 4 8 16 32 64 128 256 ON

4. OPERATING ADJUSTMENTS

DIP Switch Settings

All of the various functions of the Kaptivator™ are set up using the 10-position DIP switch

located on the rear of the unit. Using this set of switches, you can select the different

operating modes and also set up the starting DMX channel in DMX mode. The chart below

describes the various operating modes and their respective DIP switch settings.

Sound Active Mode

1.) Set the dipswitch numbers 1-9 settings to OFF, and #10 to ON.

2.)Adjustthesensitivityknobtothedesiredlevel.

Auto - Shapes

1.) Set the dipswitch numbers 1-8 settings to OFF, and #9 and #10 to ON.

Auto - Animation

1.) Set the dipswitch #1, #9 and #10 to ON, and dipswitch numbers 2-8 to OFF.

Slave Mode

1.) Set dipswitch #1 to ON and others to OFF.

DMX Mode

1.) Set dipswitch 10 to OFF.

2.)ConnectDMXOUTofcontrollertoDMXINof1stxture.DaisychainDMXOUTtoDMX

INforanyadditionalxtures.

3.)Usedipswitches1–9tosetthexturesStarting DMX Address. Each dipswitch repre-

sents a binary value in which the sum would equal the set address.

Example:TosetthexturesstartingDMXaddressto12,dipswitch#10wouldbeOFF

(DMX Mode), plus dipswitch #3 and #4 would be ON. (4+8=12).

DIPSWITCH CHART

Function

#1 #2 #3 #4 #5 #6 #7 #8 #9 #10

OFF OFF OFF OFF OFF OFF OFF OFF OFF ON Sound Active

OFF OFF OFF OFF OFF OFF OFF OFF ON ON Auto - Shapes

ON OFF OFF OFF OFF OFF OFF OFF ON ON Auto - Animation

ON OFF OFF OFF OFF OFF OFF OFF OFF OFF Slave Mode

SET DMX ADDRESS OFF DMX Mode

ON DIP

1 2 3 4 5 6 7 8 9 10