Manual

Page 14

DMX Mode

Allows the unit to be controlled by any universal DMX controller.

1.) The default mode for the xture is DMX, which appears as d001 on the LED Readout. To

select a different DMX address, using the <MENU> button, select Addr,then hit <ENTER>.

Use the <UP/DOWN> buttons to select the correct address, then hit <ENTER> to conrm.

Setting the DMX Channel Mode:

1.) To select a DMX channel mode, press the <MENU> button, then use the <UP> or

<DOWN> buttons until the display reads Chnd and press the <MENU> button. Then use

the <UP> or <DOWN> buttons until the display reaches your desired channel mode. Press the

<MENU> button to conrm.

Stand-Alone, Master/Slave, Sound Active Modes:

Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.

1.) To set the xture in Flash/Fade mode, select FLAS or FAdE. To conrm, press the

<ENTER> button.

2.) Now, you can adjust the ash settings from FL00-FL15 or the fade settings from

FA00-FA15. Then press the <ENTER> button to conrm.

3.) To use the xture in automatic mode, select ASC-, and press the <ENTER> button. Then

use the <UP/DOWN> to choose from AS00-AS15, then press the <ENTER> button to

conrm.

4.) Adjust the speed of the chase as above using SP15 (slowest) to SP00 (fastest) then

press the <ENTER> button to conrm.

5.) To set the xture as a slave unit, select SLAU, and hit <ENTER>. The unit will display a

ashing SL.AU to indicate it is in slave mode.

Sound Active Mode:

1.) To use sound active mode, select SouA, then press the <ENTER> button to conrm.

Standalone (Program) Mode:

Allows a single unit to display a variety of colors and programs without a DMX controller.

1.) To set the xture in manual mode, select Pr--.

To conrm, press the <ENTER> button.

2.) Now, select the program by using the <UP> and <DOWN> buttons to select Pr00-

Pr15. To conrm, press the <ENTER> button.

Manual Color Adjustment:

Allows the user to adjust the color balance of the xture. These settings are global, they will effect all

modes.

1.) Use the <MENU> and <UP/DOWN> button to select rL-- (Amber Level), GL-- (Warm

White Level), bL-- (Cool White Level), then hit <ENTER>.

2.) Using the <UP/DOWN> buttons, select the maximum level for each color between

x000-x255 (000=off), then hit <ENTER> to conrm.