Manual

Page 14

Additional User Adjustments

Operation

Master/Slave Mode (Master Sound, Master Auto):

This mode will allow you to link up to 32 units together without a controller.

1) Use standard DMX cables to daisy chain your units together via the DMX connector on

therearoftheunits.Forlongercablerunswesuggestaterminatoratthelastxture.

2) Choose a unit to function as the Master. Press Menu once and then press up or down

until you see “Built in”, press enter and then choose either “Audio” or “Auto”. If using

“Auto” simply choose between Auto modes 1-7, and then press enter for your chosen Auto

mode.Ifusing“Audio”simplypressenterandthexturewillthenrespondtomusicviathe

internalmicrophone.Theunitmustbetherstunitinlinetobeamasterunit.Thensimply

chain the units together using DMX cable.

Note: The master unit must be in one of the Auto or Sound modes. See the Menu Map for

setting the options in the menu and navigating the Control Board.

3)Toproperlyslaveyourxtures,gotothecontrolpanelonthexturesyouwishtoslave

and press menu until you see “Built in” and then press up or down until you see “Slave”.

Choosebetweenslavemodes1-4.Pressentertoconrm.

Note: if you would like to have the xtures inverted, this can be set in the Control board in

the menu function “Reversal” for Pan and Tilt.

Degree

You can limit the full range of both Pan and Tilt by pressing Menu until “Degree” is dis-

played. Press enter and choose “Pan” or “Tilt”. For “Pan” the ranges to choose from are

“540”,“360”,or“180”.Selectwhicheverdegreerangeyouwishandpressentertoconrm.

The default factory setting for Pan is 630.

To modify the Tilt range repeat the steps above but select “Tilt” instead. The options for Tilt

are, “270”, “180”, or “190”. Once again, select whichever degree range you wish and press

entertoconrm.ThedefaultfactorysettingforTiltis270.

DMX Mode

This mode allows the unit to be controlled by any universal DMX controller. If you are unfa-

miliar with DMX, please read the DMX Primer section.

1) Set the menu to “Address.”

2)SetyourDMXstartingaddress,andhit<ENTER>toconrm.

DMX Channel Values

TheICETRI™has4DMXchannelproles(operationmodes).Thesecanbeaccessedinthe

Control Board by pressing Menu and then press up or down until you see “Channel”, then

press enter. Choose between 8 channel, 12 channel, 18 channel, and 23 channel mode.

Pressentertoconrm.

Load Data

Press menu and then press up or down until you see “Load Data”, Press enter

and “Yes” should be displayed. Press enter one more time and factory default

settingswillberestoredonthexture.