User Manual

Page 12

Additional User Adjustments

To restore all settings to their factory defaults:

1) Use the “Load Data” function in the menu (see page 11).

Operation

Master/Slave Mode (Master Sound, Master Auto):

This mode will allow you to link up to 32 units together without a controller.

1) Use standard DMX cables to daisy chain your units together via the DMX connector on

therearoftheunits.Forlongercablerunswesuggestaterminatoratthelastxture.

2) Choose a unit to function as the Master. Turn dipswitches to the Master position on the

unit.Theunitmustbetherstunitinline.ThensimplychaintheunitstogetherusingDMX

cable.

Note: The master unit must be in one of the Auto or Sound modes. See the Menu Map for

setting the options in the menu and navigating the Control Board.

3) Adjust the “Operation” to “Slave” on the slave units, and they will react the same as the

Master unit.

Note: if you would like to have the xtures inverted, this can be set in the Control board.

DMX Mode

This mode allows the unit to be controlled by any universal DMX controller. If you are unfa-

miliar with DMX, please read the DMX Primer section.

1) Set the menu to “Address.”

2)SetyourDMXstartingaddress,andhit<ENTER>toconrm.

DMX Channel Values

TheICE60™has2DMXchannelproles(operationmodes).Thesecanbeaccessedinthe

Control Board.