Manual

Page 5

3. SETUP

Fuse Replacement

CAUTION! The HushPar™ Theatrik utilizes a high-output switch-mode power supply

with an internal fuse. Under normal operating conditions, the fuse should not require

replacement. The fuse is eld replaceable, however it is an advanced procedure suited

to qualied individuals. Should your HushPar™ Theatrik fuse require replacement, please

contact Blizzard Lighting for instructions, or to return your unit for service.

Mounting & Rigging

• Slide the barn door assembly into the grooves on the front of the xture. (optional)

• Securely connect the power cable to a power socket. Dimming can be achieved via the

use of a conventional AC dimmer pack.

• This xture may be mounted in any SAFE position provided there is enough room for

ventilation.

• It is important never to obstruct cooling vents pathway. Mount the xture using a

suitable “C” or “O” type clamp. The clamp should be rated to hold at least 10x the xture’s

weight to ensure structural stability. Do not mount to surfaces with unknown strength, and

ensure properly “rated” rigging is used when mounting xutres overhead.

• Adjust the angle of the xture by loosening both knobs and tilting the xture. After

nding the desired position, retighten both knobs.

• Safety cables MUST ALWAYS be used.

• Never mount in places where the xture will be exposed to rain, high humidity, extreme

temperature changes or restricted ventilation.

Troubleshooting

Symptom Solution

Fixture Auto-

Shut Off

If it light output has stopped, the unit may have shut itself off due to

high heat. This is to protect the xture from overheating. Clear the

cooling vents of obstructions, or return the unit for service.

Beam is Dim Check optical system and clean excess dust/grime. Also ensure that

the 220V/110V switch is in the correct position, if applicable.

No Power Check fuse, AC cord and circuit for malfunction.

Fixture Not

Responding /

Responding Er-

raticly

Make sure all connectors are seated properly and securely.

Check all cables for defects.

Reset xture(s).