Owner manual

Page 10

Fixture Linking (Master/Slave Mode)

1. Connect the (male) 3 pin connector side of the DMX cable to the output

(female) 3 pin connector of the rst xture.

2. Connect the end of the cable coming from the rst xture which will have a

(female) 3 pin connector to the input connector of the next xture consisting of

a (male) 3 pin connector. Then, proceed to connect from the output as stated

above to the input of the following xture and so on.

A quick note: Often, the setup for Master-Slave and Standalone operation

requires that the rst xture in the

chain be initialized for this purpose

via either settings in the control

panel or DIP-switches. Secondarily,

the xtures that follow may also

require a slave setting.

Check the “Operating

Adjustments” section in this

manual for complete instructions

for this type of setup and

conguration.

Mounting & Rigging

This xture may be mounted in any SAFE position provided there is enough

room for ventilation.

It is important never to obstruct the fan or vents pathway. Mount the xture

using a suitable “C” or “O” type clamp. The clamp should be rated to hold at

least 10x the xture’s weight to ensure structural stability. Do not mount to

surfaces with unknown strength, and ensure properly “rated” rigging is used

when mounting xtures overhead.

Adjust the angle of the xture by loosening both knobs and tilting the xture.

After nding the desired position, retighten both knobs.

• When selecting installation location, take into consideration lamp

replacement access (if applicable) and routine maintenance.

• Safety cables MUST ALWAYS be used.

• Never mount in places where the xture will be exposed to rain, high

humidity, extreme temperature changes or restricted ventilation.

Lighting Stand Mounting

This xture comes with an easy to use stand mounting bracket. Please make

sure the lighting stand you use is rated to safely hold the weight of this unit and

do not over-extend the lighting stand. For the safety of yourself, your audience,

and the xture... always take advantage of the use of the stand’s safety pins!