Manual

ManualsBrandsBlizzard Lighting ManualsLightingBlade RGBW (Rev A)

Page 15

Setup Mode

ID Address

IDAddressmodeallowsyoutoutilizeupto850xturesononly1DMXuniverse

whilemaintainingfullindividualcontrolovereachxture.YoucanassignID

addressestoyourxtureswithinthe

SetUp menu settings.

Navigate to the SetUp icon on the LCD display using the <UP/DOWN> buttons

and press <ENTER>. Then use <UP/DOWN> buttons to highlight

Id Code and

press the <ENTER> button

.ThenscrolltothextureIDaddressnumberthat

you’dliketoassigntothextureusing

the <UP/DOWN> buttons

, and

push the

<ENTER>buttontoconrmyourchoice.

Pan Reverse, Tilt Reverse, and Fader Delay

Reverse the settings of Pan and Tilt within this menu selection.

Use the <UP/

DOWN> buttons to scroll to

SetUp and hit the <ENTER> button. Push the

<ENTER> button again while either of these are highlighted. Then use the <UP/

DOWN> buttons to highlight

On or Off. Then push the <ENTER> button to

conrmyourchoice.

Here you can also turn On/Off the Fader Delay in the same manner (bet your

getting pretty good by now!)

1.)

OFF – Fixture dimming curve is 256 steps, linear

2.)

ON – When in 15-channel mode, and with channel 12 set between DMX values

(001-025),thexturewillslowandsmooththedimmingcurvebyaddingaddi

tional dimming steps. This is particularly noticeable during long or slow dim/fade

times.

Signal Link

1.)

OFF – Fixture will continue last known function if there is a DMX signal loss

2.)

ON – Fixture will turn off if there is a DMX signal loss

Code Wheel (Position Correction)

1.)

OFF – Fixture will not automatically attempt to auto-correct positioning

2.)

ON – Fixture will automatically attempt to auto-correct positioning

Screen Saver

1.)

OFF – No screen saver

2.)

Mode1 – Large, current DMX channel display as screen saver

2.)

Mode2 – Display will shut off