Owner's manual

Page 12

DMX Mode

Allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with

DMX, please read the DMX Primer on page #15.

1.) The ROCKLITE RGBW is capable of operating with either 4 or 8 DMX chan-

nels. To use the xture in 4-channel mode, use the <MENU> button to select

d001 on the LED Readout.

2.) To operate the xture in 8-channel mode, use the <MENU> button to select

A001 on the LED Readout.

Stand-Alone, Master/Slave, Sound Active Modes:

Allows a single or Master/Slaved units to run factory installed programs at user selectable

speeds.

1.) To set the xture in Flash/Fade mode, select

FF01-FF99 (Fade Mode,

slowest to fastest) or

CC01-CC99 To conrm, press the <ENTER> button.

2.) To use the xture in demo mode, select

dEoo, then press the <ENTER>

button to conrm.

3.) Each xture is a master by default. To set the xture as a slave, use the

<MENU> button to reach

SLAv, then press the <ENTER> button to conrm.

Sound Acitve Mode:

1.) To use sound active mode, select either

SouD.

2.) Press the <ENTER> button to conrm.

Manual Mode (Color Preset Mode):

Allows a single unit to display a variety of colors without a DMX controller.

1.) Reach the manual adjustment by using the <MENU> button to reach

b001. Adjust each color by using the <ENTER>, <UP> and <DOWN>

buttons to select

r001-r255, g001-g255, b001-b255 or u001-

u255 (Amber Segment #1, White Segment #1, White segment #2, and Amber

Segment #2, respectively), and adjusting between 1 (lowest) and 255 (highest)

for each color.

To conrm, press the <ENTER> button.