Instruction Manual

Page 5

Rear Side

9.) Power Input AC power cable input

10.)Neutrik™EtherCON®EthernetPort To connect the ethernet cable

11.) DMX IN A/B DMX signal intput

12.) DMX Out (1-8) DMX signal output

3. OPERATING INSTRUCTIONS

STARTUP VIEW:

There are 4 initial “top-tier” menu status screens (shown above) that

you’ll see when you power on the unit. You can scroll through them by

using the <UP/DOWN> buttons. The Device Name, Device ID, and

IP Address can all be edited later within the menu settings.

Intherstrowoftheportstatusscreen;A/B refers to the DMX IN

A/B, and 1-8 refers to DMX outputs 1-8. In the second row of port

statusscreen;“x” means the port is inactive, “√” means the port is

active, and “—” means the port has been set as disabled.