User Manual

Page 10

To set the unit in DMX MENU

TocontroltheCOLORStorm252inDMXMENU,rstselectfromoneofthethree

DMX control MENUs (3 Channel Mode, 9 Chnanel Mode, or 13 Channel Mode.)

1.) To select 3 Channel MENU, press the <MENU> Button, then use the <UP>

or <DOWN> Buttons until the display reads

03Ch.

2.) To select 9 Channel Mode, press the <MENU> Button, then use the <UP>

or <DOWN> Buttons until the display reads 09Ch.

3.) To select 13 Channel MENU, press the <MENU> Button, then use the <UP>

or <DOWN> Buttons until the display reads 13Ch.

To set the DMX address:

1.) Press the <MENU> button until the display reads Addr.

2.) Press the <SETUP> button until the display reads A001.

3.) Use the <UP> and <DOWN> buttons to set the appropriate DMX address.

To run one of 16 built-in programs:

1.) Press the <MENU> Button until the display reads PG00 to PG15

2.) To adjust the program speed, press the <MENU> Button until the display

reads SP00.

3.) Use the <UP> and <DOWN> buttons to set the speed between Sp00

(fastest), and Sp15 (slowest).

To set the xture to a ash or fade mode:

1.) Press the <MENU> button until the display reads FA00-FA15 (Fade,

fastest <-> slowest), or FL00-FL15 (Flash, fastest <-> slowest).

2.) Use the <UP> and <DOWN> buttons to adjust the speed.

To set the xture in Sound Active Mode:

1.) Press the <MENU> button until the display reads SouF (Sound Active

Flash Mode) orSouA (Sound Active Continuous Mode).

2.) Use the sensitivity knob to adjust sound sensitivity.

To set a custom color in Standalone Mode or adjust overall

color balance:

1.) Press the <MENU> button until the display reads r255 (Red intensity,

0-255), or G255 (Green intensity, 0-255), b255 (Blue intensity, 0-255)

2.)PleasenotethatthesesettingswilleffectthextureGLOBALLY,IEinany

mode.

To set additional units as slaves while in Program/Sound Ac-

tive/Auto MENU:

1.) Press the <MENU>, <UP> and <DOWN> buttons until the display reads

A001.