User`s manual

Blitzz Super G Wireless – 108 Mbps 802.11g Notebook Adapter
5
Follow the procedure below to install the Wireless LAN card.
1. With 68-pin connector of the card facing the CardBus slots on
notebook, slide the card all the way into an empty slot.
2. Connect to a network after installing the Blitzz WLAN Utility.
2.5 LED Indicators
The following table describes the meaning of LED indicators:
LED Meaning
POWER Indicates that the Adapter is powered on (solid
green).
LINK Indicates link status. It is normally blinking.
When blinking, indicates that the card is
scanning the channels, and the link is not
active. When lit, indicates that the card is
locked to a channel, and the link is active.
2.6 Ejecting the Wireless LAN card
After disconnecting from the LAN, you can eject the Wireless LAN card from the PC Card
slot of notebook.
Note!
In Windows XP/2000/ME/98 operating systems, you do not have to power down
the notebook to remove the card. The card is hot-swappable — you can remove
the card when the notebook is powered on. However, Microsoft recommends that
you stop the card. Refer to your Windows 2000/ME/98 online help for
information on stopping the Wireless LAN card.
Most notebooks have an eject lever or button for ejecting PC cards from the PC slots.
Consult your notebook manual for details.