Manual

H
30. Zip ties
Ｌ
①Flange bolt
② Flange bolt
2. Cover
⑧Hex bolt
⑮Washer
10. Trans. bracket
①Bolt
⑫Nut
11. Dip stick
bracket
Original dip
Stick bracket
25. Using #11 bracket, attach one end to #9
bracket (this is the bracket holding the
compressor and the intake manifold) and the
other end to the genuine dip stick brakcet.
Use
① bolt (1) and ⑫nut (1) to attach
genuine dip stick and # 11 bracket.
*note: make sure everything is secure and tighten
down.
26. Using #30 zip ties, tie down the harness
to the fuel rail.
27. Install compressor cover. Use the #5
Compressor gasket,
① bolt (4), and ②bolt
(2).
*note: make sure not to over tighten ① Flange
bolt(s).
28. Using #10 bracket, attach to transmission
as shown, using the
⑧ bolt (1), and the
⑮washer (1). *Do not secure the bracket yet.
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes