Manual

15. Attach compressor onto the intake
manifold. Make sure the #5 Compressor
gasket (1) is installed.
※ In place of stud bolt use ⑫ nut (5).
Use the
① bolt (1) for the last open hole.
16. Use #9 Compressor bracket to attach
compressor and intake manifold.
Use the ③
bolt (1), the
⑦ bolt (1), and the ⑭ nut (1) as
shown in illustration.
*Hint: Using #11 Bracket, attach flat end to
⑦ bolt, prior to bolting on #9
Compressor Bracket. Leave a little play
on #11 Bracket, it will allow the
installation of the dip stick easier. (refer
ahead to Installation #25)
17. Install
⑰Stud bolt (3) as shown in
illustration.
18. Remove transmission bolt as shown.
1. Compressor
3. Intake manifold
9. Compressor
bracket
⑦Flange bolt
③ Flange bolt
⑭Collar nut
1. Compressor
3. Intake manifold
⑰Stud bolt
Transmission
bolt
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes
Online Manual Not For Resale Purposes