Owner's manual

ManualsBrandsBLITZ ManualsEquipmentSBC i-D III

BOOST

1 In order to set desired boost

MANUAL - Setting the boost pressure manually.

Press MENU button scroll down to BOOST and

WARNING

- the number displayed does not represent actual boost

Press

button

scroll

down

BOOST

and

WARNING

the

number

displayed

does

not

represent

actual

boost

press enter. It is a ratio, 0 represents stock boost, 100 represents maximum

2 To select function, scroll down and press enter boost.

The function will be highlighted, scroll to select or set * Always start off with a low amount ratio, then adjust to preference

different setting.

IMPORTANT - Boost and EGT gauges must be used when setting the

3 To unselect, press MENU button to go to previous display. SBC I-D. Always start with the boost ratio set at low then slowly

dj t t d i d tti

adjust to desired setting.

Note: Each channel can be set differently, either to AUTO or MANUAL

BOOST

SET

CHANNEL CH1 - Shows the boost ratio or boost pressure setting

UTO / MANU

UTO 1 To chan

e boost settin

ress enter and scroll down to SET

UO/ U

o c a ge boost sett g p ess e te a d sc o do to S

SET 0.6 and press enter and scroll left or right to adjust setting.

GAIN 5 2

While in Boost Digital Displa

, the Channel and Boost setting can

GRAPH SCALE 1.0 be change without going to Boost setting. Channel and Boost

setting is located under boost digital bar. By pressing ente

Channel will be highlighted, scroll to Channel desired. Press enter

again to go to boost setting set as desired

again

boost

setting

set

desired

EXPLANATION OF EACH CATEGORY

GAIN

CHANNEL - Ratio of 0-100

Channel 1 ~ Channel 4 - Gain controls the boost response. The high the gain setting,

SBC I-D has 4 programmable boost settings. Each channel has its the faster the boost response will be. Stock turbo charged

own individual memory and will not affect any other channels. vehicles with actuator type wastegates will usually use a gain

EXT setting of 5-15 percent. External type wastegates usually

Only use with the Blitz MAP Analyzer, refer to Map Analyzer requires higher gain setting.

instructions

WARNING - High gain setting might cause boost spikes.

OFF

Note: Each channel can be set to each individual gain setting

Turns boost controller off

boost

ressure will be at stock.

Turns

boost

controller

off

boost

pressure

will

stock

GRAPH SCALE

AUTO / MANUAL You can select the graph scale that appears on your display

AUTO - Full automatic mode

screen.

1.0 ~ 1.5 ~ 2.0 ~ 2.5 kg/cm

Dial in desire amount of boost pressure to set boost example: 1.0 ~ 1.5 ~ 2.0 ~ 2.5 x100kpa

WARNING - Auto mode will not work properly on any twin 1.0 ~ 1.5 ~ 2.0 ~ 2.5 BAR

turbo sequential turbo or high boosting vehicles

10~20~30~40PSI

turbo

sequential

turbo

high

boosting

vehicles

PSI

Note: Each channel can be set to different graph scale

Page 6

Online Manual Not For Resale Purposes