Owner manual

ManualsBrandsBLITZ ManualsEquipmentDCII Meters

REV Meter Calibration

The gauge is preprogramed for 4cyl applications. To change to 6cyl. push down

the REC switch when the ignition is turned on. To change back to 4cyl hold

MODE switch down when you turn the ignition on.

To ensure accurate readings make sure you calibrate the gauge.

Push the PEAK switch when you turn on the ignition to go into calibration mode.

The red and green L.E.D.s blinks and the needle points to 3000rpm. After the

engine has warmed up to normal operating temperature rev the engine up to 3000rpm.

When the factory tachometer and RPM meter match push MODE to set and

calibration mode ends.

Sometimes under varying loads there may be a different reading from the factory

tachometer compared to the Ex Temp/REV Meter this is normal and not a malfunction.

If the variation is a considerable difference then you may need to recalibrate.

Ex.Temp/REV Warning

After ignition is turned on and meters have gone through the self-test mode

Hold down MODE button for 1 sec. Red L.E.D. should light up. Use PEAK for up

and REC for down to set RPM warning level. Push MODE 2x to set and exit

programming mode.

Quick Reference Chart

MODES OPTIONS BUTTONS TO PRESS LED STATUS(on gauges)

Reading displays Real time Green L.E.D. Flash 1x

(boost and Delay mode Press MODE once Green L.E.D. Flash 2x

pressure only ) Pass and hold Green L.E.D. Flash 3x

Speed and Ex. Real time Press MODE once Green L.E.D. Flash 1x

Temp Meter only

Power and Real time Press MODE once Green L.E.D. Flash 2x then stays on

RPM meter only Pass and hold Green L.E.D. Flash 3x then stays on

Peak hold Display Press PEAK once Yellow L.E.D. on

Reset Hold PEAK down for 2 sec. Yellow L.E.D. off

Warning Display Press MODE for 1 sec. Red L.E.D. on

Set Press PEAK Button to increase Red L.E.D. on

Press REC. button to decrease Red L.E.D. on

Replay To record Press REC. for 2 sec. Red L.E.D. Flash

To Stop record Press REC. button Red L.E.D. off

To Replay Press REC. for 4 sec. Green L.E.D. Flash

To Replay twice speed Press MODE. while in replay mode Green L.E.D. Flash faster

To Stop replay Press PEAK button All L.E.D.s off

Contrast Gauge contrast Press MODE button for 4 sec.

Press PEAK increase All L.E.D.s will be on

Press REC. to decrease

Temperature toggle 2 temp sensors are Press MODE button Green L.E.D. will be off for temp 1

( only on temp required Green L.E.D. will be on for temp 2

gauge)

Note: Regarding the Boost meter.

There are times when the needle/pointer on the boost gauge may not return to 0 after self test.

To "Zero" in the gauge hold down PEAK and REC switch on the boost gauge when you turn on the ignition. All

L.E.D.s will light up. Use the PEAK button to raise and the REC button to lower the needle/pointer to the proper

location. Push the MODE switch to return to exit programming and return the gauge to real-time monitoring.

LED blinkin

Push PEAK when turning

IGN on to calibrate

Push MODE to set

calibration and end.

Engine RPM calibration

WARNING: All images and text in this manual is the property of Blitz Co., Ltd. (Japan). No part of this may be reproduced,

stored in retrevial systems, or transmitted in any form or means with out prior written permission of Blitz Co., Ltd. (Japan).

Online Manual Not For Resale Purposes