Full Product Manual

3
Before operating your Spright Motion, please read the “Before you Begin” and “Notice” sections
of this user guide.
SETTING UP THE BLISSLIGHTS SPRIGHT MOTION
1. Connect the light xture to the provided power supply.
2. Connect the power supply into an available standard electrical outlet.
3. Attach the stake to the xture head by twisting the xture clockwise. (Remove the
stake by twisting the xture counter-clockwise.
4. Stake the light into the desired location by holding the top of the stake and gently
pushing the stake into the ground.
5. Adjust the angle of the projected light by turning the thumbscrew attached to the side
of the xture.
6. Use the included remote control to adjust the speed of the light movement.
7. To turn o the light, use the provided remote or remove the power plug from the
electrical outlet.
OPERATING THE BLISSLIGHTS SPRIGHT MOTION
The Blisslights Spright Motion operates in temperatures of -15°F to 90°F. There may be a
slight delay in projection intensity if operating in temperatures below 55°F. Please allow up
to 10 minutes for the light to warm up and reach its full projection intensity.
OPERATING THE TIMER
When you rst plug in your light, it will automatically turn on and will operate at its fastest
rotation speed. It will continue on for 6 hours, or until it is shut o using the remote control.
Using the remote control to shut o the unit also disables the timer, and every time it is
turned on, it will reset the timer.
The Blisslights Spright Motion has a built-in timer that is designed to automatically shut o
after 6 hours of operation. It will go into sleep mode for 18 hours, and resume its operation
thereafter. The rotation speed will remain at the same setting for every timer cycle, unless
you unplug the unit, which will return it to the fastest rotation speed.