Use and Care Manual

15-ft Steel Hammock Stand
For 10-ft to 13-ft Hammocks
Hardware Included:
Assembly: No tools required
End Pole
(D)
End Pole
(D)
End Pole
(C)
Holes for “Z” Hooks
(E)
(A)
(A)
Base Bracket
(B)
Base Bracket
(B)
Congratulations on your 15-ft Steel Hammock Stand purchase.
Please refer to the diagram for the assembly of your Hammock Stand.
A. (2) Round Rubber End Caps – Caps may already be attached to the end of the poles
B. (2) Base Brackets
C. (1) Base Pole
D. (2) End Poles
E. (2) “Z” Hooks
1. If Round Rubber End Caps (A) are not already on the ends of the poles, place Round
Rubber End Caps (A) on End Poles (D) near the “Z” Hook (E). See diagram.
2. Place the 2 Base Brackets (B) on the floor, and connect the Base Pole (C) to the 2 Base
Brackets (B) as shown in the diagram above.
3. Insert the 2 End Poles (D) into the other ends of the Base Brackets (B). Make sure that
you insert the side of the End Poles (D) without the holes.
4. Place the 2 “Z” Hooks (E) into the holes, which will be used to hang the hammock.
Weight Capacity: 450 LBS