Installation guide

BlipNet Administrators Guide
76
Problem when pushing objects to the OPP server in BlipNet
If pushing objects to the OPP server in BlipNet fails, there are some possible problems and
solutions. The following problems and solutions are known:
1. A lack of disk capacity on the BlipServer. Check the disk capacity on the machine on
which the BlipServer is running. There must be enough disk capacity for incoming
objects.
2. The object format of the object being pushed is not supported. See section Object Push
Server Settings describing how to verify that the object format is supported.
3. Bad radio link. The reason for a failure when pushing an object to BlipNet may also be a
bad radio link if the terminal moves out of range. Please move the terminal back into
range and try again.