Installation guide

Diagnostics
75
Problem when connecting to the OPP server in BlipNet
Before going through this procedure please make sure that the correct configuration is used.
Either the “Object Push Server”, the “LAN Access and Object Push Server” configuration or
another suitable custom configuration must be used.
If the problem remains then the procedure to find the problem depends on what the problem
appears to be from the terminal side. The following problems and solutions are known:
1. If the terminal cannot find the BlipNode in a device discovery, it may be due to the
reasons listed in section BlipNode Does Not Connect to the BlipServer item 1.
2. The terminal cannot make a service search on the BlipNode. This may be due to several
reasons, see section BlipNode Does Not Connect to the BlipServer item 2.
3. The OPP service is not available after making a service search. Verify that the Object
Push Server service is enabled, see section BlipNode Services.