Installation manual

IM0001_L2_R_WMv1.3 5
 The installer or contractor shall not modify or otherwise alter blink equipment in any manner
other than specifically authorized by this installation manual. Unauthorized modification to the
blink equipment voids the manufacturer’s warranty.
Customer responsibility
The customer is responsible for contracting with a certified electrical contractor to perform all
electrical work, including connections at the blink, supply circuit, and main service panel.
Tools required for installation
Meters
 Current Clamp Meter (with 600 A MAX AC/DC) (Recommend: Fluke
®
336)
 Digital Multimeter (1000V MAX DC/AC) (Recommend: Fluke 87V)
Hand tools
 Drill bit, 3/16-inch
 Hammer
 Pencil/marker
 Slotted and TORX
®
-head screwdrivers
 Wrench, 10 mm
 Torque wrench
Installer-supplied items
 Service wiring to blink
 Conduit and fittings (1-inch trade size), except for cord-connected units
blink features and specifications
Features
 Certified to UL 2594 – Electric Vehicle Supply Equipment
 Charge circuit interruption device (CCID20)
 Ground monitoring circuit
 Nuisance-tripping avoidance and auto re-closure
 Cold load pickup (randomized auto-restart following power outage)
 Certified energy and demand metering
 Wireless IEEE 802.11g