Installation manual

IM0001_L2_R_WMv1.3 21
Figure 14 – Location of RJ45 (Ethernet) Port
Figure 15 – Closed RJ45 (Ethernet) Port
Figure 16 – Open RJ45 (Ethernet) Port
CAUTION: The Ethernet port delivered with the blink charging system is intended for indoor use
only (such as in a garage). Contact the blink Call Center for information on the
additional requirements for a safe outdoor Ethernet connection.
To physically connect the blink to a LAN via Ethernet:
1. Unplug the black plastic cap on the RJ45 port, located on the bottom of the charger assembly
between the two knockouts. Refer to the figures above.
2. Plug in the customer-supplied Ethernet cable.