Installation manual

IM0001_L2_R_WMv1.3

11. Test the blink using ECOtality’s Car-in-a-Box equipment. Refer to the blink

Car-in-a-Box

Operator’s Manual

(OM0002_CIB) for more information.

Figure 13 – Security Seal

NOTE: The blink will make an audible “click” each time that power starts flowing from the blink to

the Car-in-a-Box, and again when power stops flowing. This is a normal sound for the blink to make.

12. When the test is successfully completed and if required, install a security seal (not provided) at the

bottom of the housing cover.

Connecting the blink to a LAN via Ethernet (optional)

A small percentage of blink owners will choose to connect their blink to the Internet over a local

area network (LAN). The blink includes an RJ45 (Ethernet) port for the physical connection; the

connection is then configured during the Network Setup process, which will generally be performed

by the blink owner. Refer to the blink

Wall Mount Charging System Owner’s Manual

for more

information about configuring a blink network connection.