Service manual

㄀ 3 义݅9 义
PRELIMINARY INFORMATION ----- SUBJECT TO CHANGE
after factory alignment.
2-WARM UP OFF OFF˖The set would enter standby mode after 15
minutes’ without input signal
ON˖Aging modeDŽAging time will display on the left
bottom of screen.
OK
3-ADC ADC calibration˄refer to page 7˅ OK
4-WHITE
BALANCE
White Balance data adjustment. (refer to page 7) OK
5-SHOP DO Reset the set after production alignment; (This
operation will remove all unnecessary factory
debug information and initiate them to default
value; The factory hotkey will be turn off.)
OK
6-NVM reset DO System initialization. Restore all data except White
Balance and ADC data; Only for R&D
OK
7-SET FAC CH DO Preset specific factory channels for specific
factory. Press left or right button to select the
factory, and then press OK to confirm.
OK
8-POWER ON LAST ON: Always turns on TV when AC power on
STB: Always goes to standby mode when AC
power on
LAST: Restore the status before the last AC power
off.
OK
9-USB UPDATE USB updateˈ˄refer to page 8˅ OK
Note: Below the factory menu, some model information are showed, including
software version, Project Name, SIACP Version, and SW release time.
ADC Submenu˖
ITEMS Default
Setting
Description Status
Source RGB/YPP(
HD)
Sources need calibration. RGB means PC
and YPP(HD) means YPbPr.
OK
R-OFFSET 128 R-OFFSET OK
G-OFFSET 128 G-OFFSET OK
B-OFFSET 128 B-OFFSET OK
R-GAIN 128 R-GAIN OK
G-GAIN 128 G-GAIN OK
B-GAIN 128 B-GAIN OK
AUTO ADC WAIT/OK With appropriate pattern (mentioned below)
inputted, press left or right key to start auto
calibration.
OK
ADC STATUS SUCCESS
/FAIL
The result of auto calibration. OK
WHITE BALANCE Submenu
ITEMS Default
Setting
Description Status