Instruction Manual

Charge on.
Page 3 0 o f 3 7 Blink IQ 2 0 0
Level 2 AC EVSE Instruction Manual 1 0 / 9 / 2 0 1 9
W i-Fi Settings
Security
Indicates the type of security which is used for the W i-Fi connection.
EAP
Mandatory for the following security methods:
IEEE8021X
User N ame
Mandatory for the following security methods:
W PA_EN TERPRISE, W PA2_EN TERPRISE, W PA2_EN TERPRISE_SHA256, IEEE8021X
Password
SSID Password to access a W i-Fi network.
W i-Fi MAC Address
The MAC address of the W i-Fi adapter.
W i-Fi Signal Strength
The signal strength (dBm) of the W i-Fi adapter.
Cellular Settings
Cellular Mode
Indicates the cellular technology which is used.
MNC
The Mobile N etwork Code of cellular service provider.
ICCID
IMSI
IMEI
The IMEI code for UMTS mobile system. e.g. 356938035643809.
MEID
The MEID code for CDMA mobile system. e.g. A0123456789012.
UMTS APN
The APN name to access a UMTS mobile network (e.g. AT&T or T-Mobile).
UMTS APN User
The APN user name to access a UMTS mobile network.
UMTS APN Password
The APN password to access a UMTS mobile network.
UMTS Dial N umber
The dial-in number to access a UMTS mobile network.
CDMA Carrier
The CDMA carrier (e.g. Sprint or Verizon)
CDMA Dial Number
The dial-in number to access a CDMA mobile network.
Primary DNS
The Primary DN S of the cellular modem.
Secondary DNS
The Secondary DNS of the cellular modem.
Cellular Signal Strength
The signal strength (dBm) of the cellular modem.
Local Load Management LLM Settings
Local Load Management
Indicates if the Local Load Management functionality is Enabled or Disabled.
Charging Policy
Indicates the applicable policy which is applied for local load management
Uniform Distribution The maximum amperage is divided by the total number of Client /
Secondary units which will use the same charging current.
FIFS First In First Served
Group ID
The identity of the LLM Group. A Client / Secondary unit with a different Group ID will be
rejected when it attempts to connect to a Gateway / Primary unit.
Group Position
The physical position order of the unit in the LLM Group.
Group Size
The number of units in the LLM Group. This setting is only used for Gateway / Primary units.
Max Amperage Grid
Connection
The maximum amperage that is available to the LLM Group.
Fallback Current
The fallback current that is used when a Client / Secondary unit is unable to communicate
with a Gateway / Primary unit. The Gateway / Primary unit will overwrite the fallback current
for a Client / Secondary unit with its own value when the Client / Secondary unit is connected
to the Gateway / Primary unit.