Instruction Manual

Charge on.
Page 1 3 o f 3 7 Blink IQ 2 0 0
Level 2 AC EVSE Instruction Manual 1 0 / 9 / 2 0 1 9
6 .3 .4 . Remove the to p co ver fro m the Blink Pro duct using a Security T2 0 driver to lo o sen the
7 screws.
Figure 3 To p Co ver Screws
6 .3 .5 .
Remove the appro priate co ver (A o r B) b ased o n the desired co nduit entry po int.
Figure 4 Co ver Removal
6 .3 .6 . (with wire) to the
N ote: Cho o se the appro priate co nduit and wire ba sed o n Ta ble 1 Conduit a nd
Brea k er Size Guide and in acco rdance with all applicable state, lo cal, and natio nal
electrical co des and standards. Use co nducto r type o ther than RHH, RHW and RHW -2 .