User Manual

Lift the head rail into position such that the inner front edge of the

head rail slides into the slot at the front of each bracket. Push the

head rail upward until the ﬂexible tab at the bottom of each bracket

snaps onto the back of the head rail. Check carefully to assure that

each bracket is properly secured.

For Outside Mounting:

Clip the brackets onto the head rail as described above. Hold the

shade level at the height desired and center it over the window

opening. Mark the exact location of each bracket with a pencil.

Remove the brackets from the head rail and position the top of each

bracket at the marked location and screw each bracket into the wall

or window molding using the 1

” screws, pre-drill the screw holes

using a 5/64" drill bit.

For Inside Mounting:

Clip the brackets onto the head rail as described above. Hold the

shade in place and make a pencil mark at the rear of each bracket

where it contacts the inside of the window frame. Remove the

brackets from the head rail and align them with the marks. Attach

each bracket using the 1

” screws, pre-drill the screw holes using a

5/64" drill bit.

Step 4. Attach Handle(s) [Applies to cordless shades only]

Attach the Handle to the bottom rail as illustrated. The handle is

designed to minimize contact with the shade fabric.

For TDBU cordless shades, attach the 2nd handle to the Middle Rail

as illustrated.