User manual

How to Use Bluetooth FM Radio Function
Turn FM ON. Headset idle status, turn and hold the Multi-Function Button (MFB) counterclockwise about 2
seconds until display shows “FM ******.” and headset turn FM on, ****** is last used radio channel ‘s frequency.
NOTE:When placing or receiving calls or intercom, FM is automatically muted.When the call is finished, FM
is resumed.
Turn FM OFF. Turn and hold the the Multi-Function Button (MFB) counterclockwise about 2 seconds until display
“FM OFF”, and headset turns FM off.
Searching FM channel automatically. When FM is on, turn the Multi-Function Button (MFB) counter clockwise
and it will seek out the next higher FM station and begin playing.When you reach the highest station and turn it
again, it will return to the lowest station and begin searching upward again.
Adjusting FM Volume. Turn the Multi-Function Button, (MFB) counter clockwise to increase the volume level.
After reaching the maximum level it will return to the minimum level and you can keep turning it to increase the
volume le
vel again. One twist increases volume by one step.Two twists increases the volume by two steps, etc.
Continue to twist to increase volume one step at time until at full volume.
How to Make Intercom Calls
RIDER. If not on an active phone call, press the Multi-Function Button (MFB), the headset will now enter the
Intercom mode.The RIDER headset will initiate an intercom call to the last paired headset automatically. Press the
MFB to terminate the call. If the RIDER headset is playing A2DP music from the phone before entering Intercom
mode, when the Intercom call ends, the RIDER headset will reconnect to the mobile phone and the music will
resume. (On some manufacturer’s phones, the headset can’t restart music playing automatically; in that case you need
to restart the headset playing manually).
PASSENGER. If not on an active phone call, it will accept the connection request from the rider headset.After
about 3-4 ringtones, the PASSENGER intercom will answer automatically. Or you can press the Multi-Function Button
(MFB), to answer the incoming call manually. Press the MFB to terminate the call. And if the PASSENGER headset is
playing A2DP music from the phone before entering Intercom mode, when the Intercom call ends, the PASSENGER
headset will reconnect to the mobile phone and the music will resume. (On some manufacturer’s phones, the headset
can’t restart music playing automatically; in that case you need to restart the headset playing manually).
The PASSENGER can also initiate an intercom call to the RIDER by pressing the MFB.You will hear 2 high tones,
then the screen will show "CONNECT" followed by a series of high tones, then "INTERCOM" will show on
the screen.
NOTE:When placing or receiving phone calls, the intercom is automatically terminated.