User manual

BLINC
™
III Bluetooth
®
Introduction
The BLINC
™
III integrated helmet communications system is based on Bluetooth
®
wireless technology. Bluetooth
®
wireless technology is a short-range radio communication technology intended to replace the cables connecting
electronic devices.The technology uses a globally available frequency range intended to ensure communication
compatibility worldwide.
You can connect your BLINC
™
III equipped helmet to your mobile phone or any device with Bluetooth
®
wireless
technology that supports the BLINC
™
III Headset profile or the Hands-free profile.When the BLINC
™
III system is
connected to your mobile phone, you can handle incoming and outgoing calls, listen to music or GPS instructions,
and adjust the volume, using the controls on the BLINC
™
III equipped helmet. It can connect to mobile phones,
music players and GPS systems that are Bluetooth
®
enabled. Its built in FM receiver let’s you tune in and listen to
FM broadcasts. It will also operate as an intercom with another BLINC
™
III equipped helmet.
The BLINC
™
III Bluetooth
®
headset system is completely built in to the helmet and consists of a microphone,
two earphones, glove-friendly controls and a battery/module unit.
To use your BLINC
™
III equipped helmet, your phone or music device should support the following
Bluetooth
®
profile:
Providing a wireless means for both remote
control of the Mobile Phone by the
Hands-free device and voice connections
between the Mobile Phone and the
Hands-free device.
HFP (Hands-free Profile)
Earphone
Control Unit
Figure 1
Blinc
™
lll Bluetooth
®
Module and Battery
BLINC
™
III Bluetooth
®
Equipped Helmet
Profile
Description
A2DP (Advanced Audio Distribution Profile)
Stereo Music Streaming
Microphone
AVRCP
MP3 Control
FM
88-108MHz