Instruction manual

11. Replacing the Battery

If you need to replace the battery, please turn o the Bluetooth Headset

before you begin.

1. Open the battery case cover.

• Push the Clasp handle in the direction of the diagram to remove the

cover and expose the battery.

2. Remove the battery from the case

Hold the handle and take out battery as shown below.

3. Replace the battery by sliding the new battery into the same position.

Then close the cover.

Note: Unless authorized to do so, do not attempt to remove the Blue-

tooth Control Unit.

12. Troubleshooting & FAQ

I hear crackling noises

• For the best audio quality, always wear your headset on the same side

of the body as your mobile phone.

I cannot hear anything in my headset

• Increase the volume on the headset.

• Ensure that the headset is paired with the sending device.

• Make sure that the phone is connected to the headset – if it does not

connect either from the phone’s Bluetooth menu or by tapping the

answer/end button, follow the pairing procedure (See section 6 and 7).

I have pairing problems even though my phone indicates otherwise

• You may have deleted your headset pairing connection in your blue-

tooth device. Follow the pairing instructions in section 7.

I cannot use Reject call, call on hold, Redial or voice dialing

These functions are dependent on your phone supporting them. Please

check your phone’s manual for further details.

Open Direction

Clasp handle

Battery

Battery Handle

Bluetooth

Control Unit