User manual

OPERATION
The Bluetooth helmet headset is a water-resistant device, designed
for use under moderate rain or snow conditions. However, the headset
is not waterproof and should not be used under severe weather conditions.
1 Please pair GPS device and please refer to the GPS navigator user
manual first to share the audio information from GPS via A2DP.
2 In phone or interoom call active and music-playing state, left twist and hold
button 2 can go to turn down the volume, right twist and hold buttom 2
can go to turn up the volume, when reaching the maximum or minimun
volume, a “DiDong” tone will be played.
3 Mobile phone or intercom calls have a higher priority than GPS audio.
Mobile phone/intercom calls will interrupt the GPS audio. The audio will
be restored automatically after the call has ended.
FUNCTIONS
>Bluetooth® Hands-free
>Last number redial
>Automatically answer call and voice dial
>Reject a call
>Independent mobile phone volume control and memorize
>Mobile phone highest priority
>Bluetooth® A2DP music Play
>Enjoy music from Mobile phone or other music sources
>Remote control music play with AVRCP
>Independent music volume control and memorize
>Music third priority after phone call and intercom
>Music volume soft restore back
BATTERY CHARGING
The unit has an embedded rechargeable battery. Please charge the unit for
appox 3 hours before use. The red LED will shine still when the battery is
fully charged.
- Please use the USB cable gently, do not pull it too hard or the headset
may be damaged.
- In order to keep the battery capacity and extend it’s life, please store the
headset in 15℃ to 25℃ environment while not use.
5
2
Supports HSP, HFF, A2DP, AVRCP, and Full Duplex
intercommunication
DWO - 3
LED Light Indicator
LED Indicator type
All LED indicator off
Red/Blue lights flashing alternately
Blue light short flashing every 3 sec.
Blue light long flashing every 3 sec.
Red Led flash 2 times every 60 minutes
Red Led indicator flash once every
second
Red Led indicator shining still
Indicated State
Power off
Pairing mode
Standby state
Connected state
Battery is low
Charging
Charging completed
MUSIC OPERATION
GPS NAVIGATOR OPERATION
SPECIFICATIONS
Note: Please do not use the headset while charging
Bluetooth Helmet Headset Bluetooth Helmet Headset
6.2.2 During any two units intercoms, the third one who is on standby state presses
Button 1 twice, it will send a connection request signal to the one of before the last
intercom partner. The being requested one will hear connection request sound of
“ringring”, and then it just double click
Button 1 , it will begin to intercom, or just do
nothing to ignore the request.
6.2.3 If the either one of the two talking riders wants to talk to the third one who
is on standby state, it just double click
Button 1 to initiate intercom.