Operation Manual
54
• Additional literature may be included depending on package conguration.
1. Remove blender motor base, blender jar, and lid from packaging.
2� Unwind the power cord�
3. Check for any packing material that may have blocked ventilation holes
on the underside of the blender motor base�
4� Inspect all items to ensure no damage occurred during shipment�
5� If any damage has occurred contact your Blendtec service agent immediately�
2.2 RECORDING YOUR SERIAL NUMBER AND DATE OF PURCHASE
Record your blender motor serial number and date of purchase in the space
below� You will need these when contacting Blendtec for service or questions�
Motor Serial #(Found on bottom of motor base): __________________________________
Date of Purchase: ____________________________________________________
Purchased From: _____________________________________________________
2.3 REGISTRATION OF YOUR BLENDER
Register online at www�blendtec�com/registration
SECTION 3: GETTING TO KNOW YOUR BLENDER
(Refer to Figures 1 and 2)
3.1 BLENDER MOTOR BASE
• Touch Pad: Consists of six buttons that contain pre-programmed settings
for selective blender control, a pulse button, and two speed control buttons�
• Blender Drive Socket: This is where the jar couples with the motor to turn the
blade assembly�
• LCD Information Center: Indicates status of unit as well as possible failure
conditions� It also displays the number of times a blend cycle button has
been pressed�
• Power Unit: This unit is located within the blender motor base and contains
the computerized electronics that run the blender�
3.2 BLENDER JAR ASSEMBLY
The blender jar assembly consists of the blender jar, blade assembly, and lid�
• Lid: Flexible rubber lid seals liquids within the jar during blending; clear
durable plastic insert allows air and steam pressure to escape as well as
ingredient addition without removing the entire lid�
• Jar: Made from a tough durable material to provide maximum efciency
and clear visibility of blender performance�
• Blade Assembly: Uniquely designed stainless steel blade provides fast,
consistent blending�
• Motor Base Cover: Houses the power unit in a durable, plastic material.
• Power Switch: Located on the back lower-right corner of the motor
base cover�
• Power Cord: Located at the back of the motor base cover.
NOTE: Filling the blender jar beyond the marked capacity is not recommended.
Blender Drive
Socket
Power Unit
Touch Pad
LCD Information
Center
Lid
Jar
Blade Assembly
Motor Base Cover
Power Switch
Power Cord
FIGURE 2 SIDE VIEW: MOTOR BASE AND JAR ASSEMBLY
FIGURE 1 FRONT VIEW: MOTOR BASE