Owner`s manual

54
SECTION 2: UNPACKING
Note: Save all packaging materials and instructions for future use�
2.1 UNPACKING YOUR BLENDER
You should have received the following items:
• Signature Series motor base
• Blender jar with vented lid
• FreshBlendsrecipe book and WildSideJarRecipes book
• Owner’s manual
• Other accessories included in package offering
Additional literature may have been included depending on the package configuration�
To unpack your blender:
• Remove the blender motor base, jar and lid from the packaging�
• Unwind the power cord�
• Check for and remove any packing material blocking ventilation holes
on the underside of the blender motor base�
• Inspect all items to ensure no damage occurred during shipping�
• If any damage has occurred, immediately call 1-800-BLENDTEC
or 801-222-0888�
2.2 RECORDING THE SERIAL NUMBER AND DATE OF PURCHASE
Record the blender motor serial number, date of purchase and place of
purchase in the spaces below� You will need this information if you contact
Blendtec for service or questions�
Motor Serial No� (found on bottom of motor base): ___________________________
Date of Purchase: ________________________________________________________
Place of Purchase:________________________________________________________
2.3 REGISTERING YOUR BLENDER
Register your blender online at www�blendtec�com/registration�
SECTION 3: GETTING TO KNOW YOUR BLENDER
3.1 BLENDER JAR ASSEMBLY
The blender jar assembly consists of the following (see Figure 1):
• Lid: The flexible rubber lid keeps liquids in the jar during blending�
• Clear vented lid insert: Durable plastic; allows air and steam to escape�
Can be removed for adding ingredients without removing the entire lid�
• Jar: Made from a durable, lightweight BPA-free material to provide
maximum efficiency and visibility�
• Blade assembly: Uniquely designed stainless steel blade provides
fast, consistent blending� Blade assembly is permanently attached�
3.2 BLENDER MOTOR BASE
The blender motor base consists of the following (see Figure 2):
• Blender drive socket: Where the jar couples with the motor to turn the
blade assembly�
• Touch pad: Features 12 buttons—5 buttons for preprogrammed blend
cycles, 5 motor speed buttons, 1 pulse button and 1 stop button�
• LCD information center: Indicates status of unit as well as possible
failure conditions� Also displays the number of times a blend cycle
button has been pressed�
• Power unit: Located in the blender motor base� Contains the electronics
that run the blender�
Blender Jar
Motor Base