Operating instructions

9
2. Remove blender motor base, sound enclosure components, blender jars, and
lids from carton.
3. Unwind the power cord.
4. Check for and remove any packing material which may have blocked
ventilation holes in either the power unit or the black motor stand.
5. Inspect all items to ensure no damage occurred in shipment.
6. If any damage has occurred contact your Blendtec service agent
immediately.
3.2 RECORDING YOUR SERIAL NUMBER AND DATE OF SHIPMENT
Record your blender base serial number and date of purchase in the space
below. You will need these when contacting Blendtec for service.
Blender Serial No. ____________________________________
Date of Purchase ___________________________________
Refer to these whenever contacting your Blendtec service agent.
SECTION 4: INSTALLATION
4.1 Above Counter Installation
(For SpaceSaver model, disregard mention of sound enclosure and motor
stand.)
1. Ensure that an electrical receptacle is readily accessible when you locate
the equipment.
2. Be sure the unit is switched off and unplugged. Remove the lid by lifting the
top straight off the bottom. Lay the sound enclosure top aside.
3. Route the power cord from the top through the bottom of the clear sound
enclosure bottom. Remove the bottom cover on the motor stand. Insert the
motor base carefully into the opening in the bottom of the motor stand. Be
sure the rubber gasket fits smoothly and tightly into the motor stand.