Operating instructions

11
the equipment.
2. Remove the clear sound enclosure lid (top) by lifting the top portion of the
sound enclosure off. Place the clear sound enclosure bottom on the counter
making sure the hole in the bottom of the sound enclosure is aligned with the
hole in the counter top.
3. Thread the power cord through the base of the sound enclosure and the
counter top hole being careful not to scratch or damage the enclosure.
4. Gently place the motor into the sound enclosure and slide it into the hole
in the countertop. Make sure the LCD indicator and touchpad are facing the
operator’s side of the counter. Also ensure that the rubber gasket on the motor
fits snugly and evenly into the sound enclosure and countertop holes.
5. Carefully re-install the sound enclosure lid. Never drop or slam enclosure lid.
6. Plug the unit into a receptacle with appropriate protection. Make sure power
switch is turned off before plugging unit in.
SECTION 5: OPERATING INSTRUCTIONS
5.1 OPERATIONAL OVERVIEW
1. Raise the sound enclosure lid. If blender is not turned on, turn on the main
power switch located on the front of the blender motor.
2. Place the properly filled blender jar on the motor base, making sure the jar
is seated all the way down into the motor drive socket and jar lid is secured
tightly on the jar.
3. Press the button on the touchpad of your desired blender cycle.
5.2 AUTOMATIC CYCLE OPERATION
If not otherwise specified, Blendtec blenders are programmed to the default
Multipurpose (MULTI) blender program. See the Blendtec Cycle
Chart included with this manual for details regarding programming and
operation of your blender. This chart can also be found online at blendtec.com.
5.3 MANUAL OPERATION
Pulse Button: Blends mixture at a constant HIGH speed (70 percent power)
while button is depressed. Generally this is the last button on the far right of
the blender touchpad and is indicated by the letter “P”. This button is normally
used for additional blending once a programmed cycle has already been used.