User manual

9
3.2 RECORDING YOUR SERIAL NUMBER AND DATE OF SHIPMENT
Record your blender base serial number and date of purchase in the
space below. You will need these when contacting Blendtec for service.
Blender Serial No. ____________________________________
Date of Purchase ___________________________________
Refer to these whenever contacting your Blendtec service agent.
SECTION 4: INSTALLATION
4.1 Above Counter Installation
1. Ensure that an electrical receptacle is readily accessible where you
locate the equipment.
2. When you receive your Chef blender, the motor base will ship inside the motor
base stand. Please make sure the unit is switched off before assembling.
3. To use the unit in an above counter application, make sure once the motor base
is in place that the rubber gasket fits smooth and tight. (If you also have the optional
sound enclosure, first remove the top lid of the sound enclosure and set it aside, then
remove the motor base from the motor base stand and set the sound enclosure on
top of the motor base stand. Place the motor base back into the motor base stand
and make sure the rubber gasket is smooth and tight, then replace the top lid on the
sound enclosure.
4. Make sure the touch pad is facing the front of the stand and extend the cord out of
the bottom of the stand to its full length.
5. Set the equipment on the counter and plug it into the available dedicated electrical
outlet with adequate protection per local electrical codes.
6. Ensure clearance above the counter around the installation to allow for
unhampered operation of the sound enclosure.
7. When using the optional sound enclosure, a different gasket is required so
the motor base will line up properly in the motor base stand. If you do not have
the optional gasket one may be obtained by calling your local dealer or Blendtec
customer service.